Results 1 to 4 of 4

Thread: PC pad problem

  1. #1

    Join Date
    Feb 2004
    Location
    NY
    Posts
    689
    Post Thanks / Like

    PC pad problem

    I think I out my PC pads away while they were damp after washing. Took them out today to use and they had spots of mold on them. Not a lot but a few spots. Are they toast? Can they be saved/used?

  2. #2

    Join Date
    Apr 2004
    Location
    Calgary, Canada
    Posts
    393
    Post Thanks / Like
    Mould won`t hurt anything as long as they are fairly intact, just wash them out with warm water.
    Cliff Claven is my hero
    2007 Silver Accord EX
    1999 Silver F-150 XLT

  3. #3

    Join Date
    Feb 2004
    Location
    NY
    Posts
    689
    Post Thanks / Like
    They are very much in tact. It happened the first time I used them. Thank you for you response

  4. #4
    69 GTO Judge's Avatar
    Join Date
    May 2004
    Location
    Upstate NY
    Posts
    101
    Post Thanks / Like
    Dalton,

    Same thing happened to me with the mold. I then cleaned them by hand in my sink and put a little Oxy Clean in the warm water. I tried the Oxy clean only because the pad is getting old and I figured if it damaged the pad so what. I was amazed that it cleaned the pad so that it almost looked new again and also removed the mold. .
    1969 GTO Judge 2002 Ford Escape

 

 

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. SFX-3 problem
    By CoryB in forum Car Detailing Product Discussion
    Replies: 4
    Last Post: 06-10-2008, 11:14 AM
  2. UDM problem, can I fix it myself?
    By Scottwax in forum Autopia-carcare.com
    Replies: 13
    Last Post: 03-28-2008, 03:17 PM
  3. LC pad problem
    By froll in forum Car Detailing Product Discussion
    Replies: 4
    Last Post: 07-01-2006, 02:32 AM
  4. You know you have a problem when....
    By artm3 in forum Car Detailing
    Replies: 20
    Last Post: 12-31-2004, 02:39 PM
  5. Help with Problem!!
    By Brady in forum Machine Polishing & Sanding
    Replies: 12
    Last Post: 12-22-2004, 07:36 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •